|
Magnetic Card Reader Wiring
Connections for the
Psion Organiser II Top Slot (D).
 |
Pin 1 | GND | Ground |
| Pin 2 | |||
| Pin 3 | |||
| Pin 4 | |||
| Pin 5 | |||
| Pin 6 | |||
| Pin 7 | |||
| Pin 8 | |||
| Pin 9 | RDD | Read Data Line (This changes to a logic "1" level when a "1" bit is read from the card). | |
| Pin 10 | RCP | Clock Pulse for synchronisation of reading data (This is used to sample the data line and changes to a logic "1" when clock signals encoded on a card are detected). | |
| Pin 11 | CLS | Card Detect detects presence of a card in the Swipe Reader (This goes to a logic "1" while Data is being read from the card). | |
| Pin 12 | Vcc | Power Supply +5 Volts | |
| Pin 13 | GND | Ground |
The other pins are not used though Pin 13 can be used for Ground as it is connected to the same circuit as pins 1 and 2 which are also Ground.
The information in this data sheet is accepted for use entirely at your own risk. The Psion Organiser II team will not be held responsible in any way for your use of this information.
| These pages should be viewed using Netscape 4.03 or Microsoft Internet Explorer 3.02 at 800x600 pixels. | ||||
 |
Bar Code Interface | ~ Homepage ~ | Bar Code Int / Comms Link |  |