|
Dual Magnetic Card Reader /
Comms Link Wiring Connections
for the Psion Organiser II Top Slot (D).
 |
Pin 1 | GND | Ground. |
| Pin 2 | GND | Ground. | |
| Pin 3 | DSR | Data Set Ready. | |
| Pin 4 | DTR | Data Terminal Ready. | |
| Pin 5 | RTS | Request to Send. | |
| Pin 6 | CLS | Clear to Send. | |
| Pin 7 | TxD | Transmit Data. | |
| Pin 8 | RxD |
Receive Data. | |
| Pin 9 | RDD | Read Data Line (This changes to a logic "1" level when a "1" bit is read from the card). | |
| Pin 10 | RCP | Clock Pulse for synchronisation of reading-data (This is used to sample the data line and changes to a logic "1" when clock signals encoded on a card are detected). | |
| Pin 11 | CLS | Card Detect. Detects presence of a card in the Swipe Reader (This goes to logic "1" while Data is being read from the card). | |
| Pin 12 | Vcc | Power Supply +5 Volts. | |
| Pin 13 | GND | Ground. |
(Magnetic Card Reader connections are in Red.)
The information in this data sheet is accepted for use entirely at your own risk. The Psion Organiser II team will not be held responsible in any way for your use of this information.
| These pages should be viewed using Netscape 4.03 or Microsoft Internet Explorer 3.02 at 800x600 pixels. | ||||
 |
Bar Code Int / Comms Link | ~ Homepage ~ | Top Slot Hardware Overview |  |